Wireshark Ruckus Odroid Remote Packet Capture

To do a remote packet with Wireshark for Ruckus Access Point, you will need to SSH into the Master Access Point in order to run the following commands

This sets up packet capture on 2.4GHz radio

set capture wlan100 stream

This displays status of 2.4GHz radio capture

get capture wlan100 state

To stop the capture on 2.4GHz radio

set capture wlan100 idle

This sets up packet capture on 5GHz radio

set capture wlan101 stream

This displays status of 5GHz radio capture

get capture wlan101 state

To stop the capture on 5GHz radio

set capture wlan101 idle